How Do You Install Dirt Bike Graphics

Substance Incorporated is our long-term partner for dirt bike graphics. Substance Incorporated, a market leader in motocross graphics technology for screen and digital printing, is a company that has unmatched passion and innovation. When you want to find out effective information about dirtbike, you must look at https://www.ebay.com/str/decallab?fbclid=IwAR1GW31Md9ok6Wgdi8nBEZxnUXFGI_yMztob3HbmdJiN6iVg2av6z09xIDI site.

Before you begin,

It is important to check the plastics. If they're damaged or scratched or damaged, you might consider replacing the plastics. Your dirt bike graphics kit needs to be in good shape before you install them.

To install dirt bike graphics you will need:
Adhesive paper tape
paper knife / scissors;
A hair dryer or a heat gun
alcohol-water or degreasing agents;
squeegee (optional);

Cleanse your hands. While preparing surfaces or using MX graphics, it's important to clean your hands. Dirt bike graphics won't be able to stick to dirt bikes if their hands are oily or dirty.

Preparing surface
Before you begin installing dirt bike graphics you have to remove old decals. Hair dryers or heat gun to warm old graphics to make them easier to remove. Utilize a degreasing product to clean the surface. It is essential to get rid of any glue residue, oil or dirt that may have accumulated on old graphics. The dirt bike's plastics must be warm before applying motocross graphics. Plastics shouldn't be kept in temperatures of more than 15°C/60°F longer than a couple of hours.

Applying graphics
Place your dirt bike graphics over the plastic (e.g. Number plate Tape the decal to your plastic with adhesive tape. This will hold your decal in position. You can apply any amount of tape you want.

The backing paper must be removed from the background and cut it. Check your alignment on the area to be covered. To position the graphic on one side, simply touch it by using your finger.

By working in smaller sections, use your thumb (or squeezer) to apply pressure to the graphics being careful not to get bubbles or wrinkles. The work should be done from the middle out. The bubbles can be removed by gently peeling it off and then retry. To pop small air bubbles, use the safety pin. Then smooth the bubble section moving towards the edges of the decal. Repeat the installation process on the other side of the same decal.

If you have sharp curves in the plastic (e.g. number plate on exhaust pipe) Use a the heat gun to warm the graphics until they are more flexible. Make sure not to overheat the graphics!

We suggest using a knife made of paper to cut off any excess parts of the mx graphics covering bolts, access holes or vent slits.

Installation tips
Take your time and be patient! It's not that difficult to install dirt bike graphics.
Make sure to keep your dirt bike as well as your plastics at a temperature of more than 15°C/60°F for a few hours prior to installation.
To ensure proper bonding, wait at least 24 hours before riding.